96
Model E1070 Indicator Service Manual
TOP (Peak) Application 1. From previous step 15, press the UNITS key. . .
TOP is displayed. Use this item to clear and print reports for the
peak application.
2. Press the PRINT key. . .
PRINT is displayed. Use this item to print out a complete report of
peak application information.
3. Press the PRINT key . . .
Port 1 or PORT 2 is displayed. Use this item to select which port
to use for printing the report.
4. Toggle between PORT 1 and PORT 2 using the TARE or UNITS key.
Press the ENTER key when the choice you want is displayed. . .
Display shows BUSY briefly then returns to PRINT.
5. Press the UNITS key. . .
CLEAR is displayed. Use this item to clear all the information
stored for this application. WARNING - Only do this if you are
sure you want the information permanently removed!
You may want to print out the report before clearing all the infor-
mation. See step 2 above.
6. Press the PRINT key to clear all the information
OR
Skip to step 7. . .
SURE? is displayed. This is asking if you are sure you want to
clear the information. If you are, press the ENTER key. If you do
not want to clear the data, press the SELECT key. . .
CLEAR is displayed.
7. Press the SELECT key. . .
Top is displayed.
8. Press the SELECT key. . .
APP is displayed.
Supervisor Menu—(continued)
To Next Page
Loading...
