Setting Up MultiLink
600-00078-001 Rev 05 -131- Avidyne EX500/EX600 MFD
11.3 Setting Up MultiLink
For the most part, you will have already performed the steps required
to set up MultiLink when you set up datalink as follows:
● Broadcast datalink as described in This section contains the
following information: on page 123.
● Iridium 2-way datalink as described in Setting Up Datalink for
Iridium on page 103.
● ORBCOMM 2-way datalink as described in Setting Up Datalink
for ORBCOMM (Release 4.0 and earlier) on page 113.
After you have activated the Broadcast receiver, log in to your
account on www.MyAvidyne.com
and click on Flight Center to set up
your MultiLink account.
Note: After enabling Multilink and the desired weather services, you
might be charged for the 2-Way Datalink services.
Figure 11.1 MyAvidyne Page
Note: If the Flight Center key is not displayed on your MyAvidyne
page, the NOC has not yet detected the Broadcast receiver.
Try activating the Broadcast receiver again as described in
What is Next? on page 125.
To Next Page
Loading...
Need help?
General
