Avigilon ALTA - Page 85

l
Tampersensorisenabled(default).Whenenabled,thevideoreaderwillrecordTamperDetected
eventswhenthevideoreaderistouchedormoved.
l
AdjusttheTampersensorsensitivity,lowerorhigher,dependingonyourneeds.
Note:Ahighersensitivitylevelmayproducefalsetamperevents,forexample,whensomeone
triggersaTouchtoUnlock.
7. ClickSave.
Fornextsteps,see:
l
Addzonesonpage52ifnotcreatedyet.
l
Addentriesonpage56andenterthedeviceintheControllerfield.
Note:Duringthisstep,youcanconfiguretheWiegandportonthevideointercomreader,asaninput
oroutput,forMobileGatewaymode.
l
InstallingtheVideoReaderPro/VideoReaderIntercomPro
1
Or,seetheQuickStartGuideintheboxortheOpenpathAccessControlSystemInstallationGuide.
Afterprovisioning,returntotheControlCentertofinishconfiguringvideosettingsortoenableONVIF.
Configurevideosettings
Editvideosettings
1. Goto Devices>Videoreaders,andselectavideoreader.
2. SelecttheVideotab.
l
IntheVIDEOPROPERTIESsection:

o
SelectHigh,Medium,orLowquality.

o
AdjustBrightness,Contrast,Saturation,andSharpness.
1
Formoreinformation,see:https://openpath.atlassian.net/servicedesk/customer/portal/16/article/1668284452?src=1724573529
85