Avigilon ALTA - Page 86


o
LeaveWideDynamicRange(WDR)asdisabled(default),orenabletoadjustfor
backlightingandotherextremelightingconditions.

o
LeaveNightmodeasAuto(default),orsettoAlwaysonorAlwaysoff.

o
LeaveAnti-Overexposureasenabled(default)toreduceIRglareonpersonsandobjects
approachingthevideoreader.
l
IntheDETECTIONSETTINGSsection:

o
LeaveEnablemotiondetectionasenabled(default)ordisabletoadjustsensitivitysettings.

o
Inthelivevideofeed,clickanddragonthefeedtoaddprivacyareasorregionsofinterest.
PrivacyMask—Hidessensitiveareasofthefeedfromusers.
RegionofInterest—Appliesmotiondetectiontoonlythemarkedareas.
l
IntheRECORDINGSETTINGSsection:

o
LeaveBurncurrenttimeintorecordingsandBurncameranameintorecordingsasenabled
(default)ordisablethesettings.
3. ClickSave.
EnableONVIF
EnableONVIFifyouareexportingvideotoathird-partyVMS.
1. SelecttheEnableONVIFtoggle(offbydefault).
2. ClickOpencameraUI.
Note:Forbestresults,useChrome,Firefox,orMicrosoftEdge.
3.
Loginusingthedefaultusernameandpassword,thengoto Configurations>Security>User
accountstochangethepassword.
Note:TheControlCenteralwaysdisplaysthedefaultpassword,evenifyouchangethepasswordin
theCameraUI.Toresetthepasswordbacktothedefault,disableONVIF,wait10seconds,then
enableagain.
86