Instruction manual - English - EN
25MNGCEVO_2116_EN
Place the unit body on the base aligning the
reference marks. Be especially careful not to damage
internal components during installation.
Fig. 31
To avoid scratching the product with the hexagonal
wrench, align the groove on the body of the product
with the screw before screwing it in (Fig. 32, page 25).
Fig. 32
Fasten the upper unit to the base using the 3 fixing
screws.
Pay attention to the fixing. Tightening
torque: 4.5Nm (±0.2Nm).
Apply thread-locker into the holes for
screws (Loctite 222®).
Fig. 33
To Next Page
Loading...
