Instruction manual - English - EN
27MNGCEVO_2116_EN
10 Maintenance
Before carrying out any type of
maintenance, read the "Safety rules"
chapter carefully in the product manual.
CAUTION! Device installation and
maintaining must be performed by
specialist technical staff only.
When contacting AVIGILON for assistance please
provide the serial number and the identification code
of the model.
Use only AVIGILON original spare parts.
10.1 Routine maintenance (to be
performed on a periodic basis)
10.1.1 Inspecting the cables
The cables should not show signs of damage or wear,
which could generate hazardous situations. In cases
of damaged or worn cables, repair or replacement
will be required.
10.1.2 Replacement of the wiper blade
For further details on wiper replacement
and use, refer to the manual included with
the wiper replacement part.
10.2 Extraordinary maintenance
(to be done only under particular
circumstances)
10.2.1 Reset to Factory Default Settings
It is possible to reset to the factory default settings if
the device is no longer functioning as expected.
The effect of the Factory Default procedure is the
same as restoring the factory default settings through
the web interface (Hard Reset button).
To execute the default factory procedure, you need
to access the DIP switch (S1) on the connectors' card (
Fig. 21, page 21).
Follow the procedure below:
• Disconnect the power supply to the unit.
• Open the base of the product (6.2 Opening the
base of the product, page 17).
• Set DIP 1 of switch S1 ON.
Function S1 Description
DIP 1 DIP 2 –
Reset to Fac
-
tory Default
Settings
ON – Enabled
OFF – Disabled
Tab. 5
1
ON
2
S1
Fig. 34