Avigilon H5A - 10.2.1 Reset to Factory Default Settings

EN - English - Instruction manual
28 MNGCEVO_2116_EN
• Assemble the upper body (6.13 Installation of the
upper body, page 24).
• Power the unit. Wait for 2 minutes.
• Disconnect the power supply to the unit.
• Open the base of the product (6.2 Opening the
base of the product, page 17).
• Reset DIP 1 of switch S1 OFF.
1
ON
2
S1
Fig. 35
• Assemble the upper body (6.13 Installation of the
upper body, page 24).
• Power the unit.
Once the factory default procedure has
finished, you need to configure the unit as
described in chapter: 8.1 Default IP address,
page 26.
11 Cleaning
11.1 Cleaning the window and
plastic parts
Avoid ethyl alcohol, solvents, hydrogenated
hydrocarbide, strong acid and alkali. Such
products may irreparably damage the
surface.
We recommend using a soft cloth with neutral soap
diluted with water or specific products to clean the
lenses.