EasyManua.ls Logo

Axis Wake Research A20 - Glove Box; Heated Driversseat

Default Icon
137 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
HEATED
DRIVER’S
SEAT
No one should sit or ride on the sun pads when the boat
engine is running. Carbon monoxide is emied from the
exhaust system and vented into the water beneath the swim
plaorm. Fumes can and do reach the sun pad area. Avoidance
of carbon monoxide poisoning is addressed in the Safety
secon of this Owners Manual.
It is crical to the long-term use and enjoyment of the
boat to perform the roune maintenance required to keep all
interior upholstery in top condion. Details are provided in the
Care and Maintenance secon of this Owners Manual.
Models: Seang varies by model. Check the Quick
Reference Guide.
Among the opons available on all models is a heated drivers
seat.
The heat opon is controlled through the dash MTC screen.
Turned ON, the heat sensor warms the drivers seat only to a
predetermined, but moderate level. The heat feature should always be
turned OFF at the conclusion of the oung, if not before. If the driver
forgets to turn OFF the seat, when the boat is powered down the seat
heater will shut o aer a predetermined amount of me.
Models: (Oponal) All models.
Axis recommends storing this Owners Manual in the glovebox so that it will always be readily
available for reference during oungs. Placing the Owners Manual in a plasc bag will increase its
protecon.
The glovebox is convenient for storing personal items while boang. While the glovebox is not water
proof, its design reduces the likelihood of damage from water that may come on-board. Axis does not
warrant the level of water-resistance available when using the glovebox.
The glovebox opens by pushing on the buon on the front of the lid and turning the buon when it
releases. Closing requires only liing and shung the lid ght. Closing requires minimal eort. If more eort
is required, it is likely the glovebox is overloaded and some material should be removed prior to closing.
Never attempt to close an overloaded glovebox. Trying to force
the lid closed could result in damage that is not covered under
warranty. Avoid pinching fingers, hands and other body parts
while closing the glovebox lid.
Do not store any aerosol items in the glovebox. These can overheat, leak and/or rupture. Any liquid or
semi-liquid material placed in the glovebox may spill or overheat. Care should always be used when placing
liquids such as suntan loon in the glovebox. Axis is not responsible for such misjudgments.
If any water does intrude into the glovebox, clean it out as soon as praccal. Mold and mildew can result
if even small amounts of water are not removed. As with any storage locaon, any spills should be cleaned
eciently to avoid damage and/or odors.
Models: All models have a glovebox located forward of and adjacent to the observer seat.
2016 Axis Wake Research Owner’s Manual . . . Page 2-33
GLOVE BOX

Table of Contents