Azbil SDC15 User Manual

6-9
■ AT (auto tuning) Stop/Start selection setup
(1) In the operation display mode, keep the [para] key
pressed for 2 sec. or longer.
>> The unit then enters the parameter setting mode.
(2) Press the [para] key several times.
>> Display the parameter setting [At: AT Stop/Start
selection].
(3) Press the [], or []key to set the value you have
selected from the following in [At].
At.oF: AT stop
At.on: AT start
>> When no keys are pressed for 2 sec. or longer, the flashing of the numeric
value is stopped to set the currently displayed value.
(4) Press the [mode] key.
>> The display is returned to the operation display.
Handling Precautions
When the operation type of any of internal contacts 1 to 3 is set at “AT
Stop/Start selection”, [At] cannot be changed.
When using the AT function,
refer to 8-1 AT (auto tuning) function (on page 8-2).
<
<
Chapter 6. SETTINGS DURING OPERATION
rdy
man
ev1 ev2 ev3 ot1 ot2
para
mode
pv
sp
rdy
man
ev1 ev2 ev3 ot1 ot2
para
mode
pv
sp

Azbil SDC15 Specifications

General

Brand	Azbil
Model	SDC15
Category	Controller
Language	English