10 - 2011
INDEX OF FIGURES
Figure 1: Principle components of the Combo – T 8
Figure 2: Dimensions 9
Figure 3: Connection of the interface board 10
Figure 4: Description of components of the validator 19
Figure 5: Connections of the validator 21
Figure 6: Refund module 22
Figure 7: Sorter without validator 22
Figure 8: Diagram refund module non-autonomous 23
Figure 9: Diagram refund module autonomous 23
Figure 10: Components of the sorter module 25
Figure 11: Paths of classification 26
Figure 12: Diagram of classification 26
Figure 13: Electronic circuit board 28
Figure 14: Description of the Escrow module 29
Figure 15: Dimensions of the escrow module 30
Figure 16: Description of the Hopper U-II 32
Figure 17: Extraction disks 34
Figure 18: Blades 34
Figure 19: View interior of the extraction device 35
Figure 20: Dimensions 35
Figure 21: Electronic circuit board Hopper U-II ccTalk 36
Figure 22: Interface ccTalk Hopper U-II 37
Figure 23: Location of dipswitches for configuration 38
Figure 24: Description of the Discriminator 41
Figure 25: Extraction disks 44
Figure 26: Blade 44
Figure 27: Dimensions 45
Figure 28: Electronic circuit board 46
Figure 29: Location of dipswitches for configuration 47
Figure 30: Description of connections 52
Figure 31: Screenshot off the application HeUs 56
Figure 32: Tool TL20 57
Figure 33: Screenshot of the application ccTalk Manager 57
Figure 34: Interface USB – ccTalk 58
Figure 35: Interface RS232 – ccTalk 59
To Next Page
Loading...
Need help?
General