10 - 2010
5.7.4 Description of the ccTalk commands
CcTalk addresses of the interface board
The interface board, by default, has the cctalk address 80 (decimal) assigned. It is possible to
change this address for any of the 85-89 range, using the command ccTalk [251] Address
change.
List of commands
Table 37: List of ccTalk commands
Code Command
254 Simple poll
253 Address poll
252 Address clash
251 Address change
250 Address random
246 Request manufacturer ID
245 Request equipment category id
244 Request product code
242 Request serial number
241 Request software revision
192 Request build code
141 Request firmware upgrade capability
140 Upload firmware
139 Begin firmware upgrade
138 Finish firmware upgrade
96 Request modules information
72 Request inputs status
71 Control motor refund
70 Control escrow (V retainer)
4 Request comms revision
1 Reset device
To Next Page
Loading...
Need help?
General