10 - 2010
Header 71: Control motor refund
Transmitted data: <none>
Received data: ACK
This command is used to activate the refund motor. This will stop if its input is set to 0 (stop
motor = ON)
Header 70: Control V retainer
Transmitted data: [charge/refund]
Received data: ACK
This command is used to activate the V retainer. Depending on the command received
(charge/payment), it will send the order to the V retainer to open one flap or the other for a
specified time.
[charge/refund]
1 – charge
2 – refund
To Next Page
Loading...
Need help?
General