OmniCare EVC System
Installation & Commissioning Manual
OmniCare issue 1
19
C
O
M
M
U
N
I
C
A
T
I
O
N
S
3 Hardware Installation
This chapter describes how to terminate the cabling and connect
the Remote Units, and how to mount the OmniCare EVC System
Master (& Slave) Panels.
It is assumed that the cable runs have already been installed
according to the System Designer’s specification.
3.1 TOOLS REQUIRED
To install the OmniCare EVC System equipment the following
tools will be required:
• Tools for fixing the control panel on a vertical surface,
• A small flat-bladed (terminal) screwdriver,
• A large Posi-drive screwdriver for internal screws,
• A T20 Torx Tamperproof screwdriver if Advance Remote
Units are being used (bit supplied with each Remote Unit),
• A pair of wire cutters/strippers appropriate for the type of
cable used,
• Ferules and ferruling tool for dressing the ends of cables (if
stranded conductors are used),
• Digital Multimeter for voltage and continuity tests,
To Next Page