Banner EZ-SCREEN - Page 53

Trip Output Configured
Operating Mode Required
Event
Reset
Indicator
Status Indicator Zone Indicators Diagnostic Displays OSSD
Outputs
Power-up
Apply
power
Off
Single-Flash
Red
All Single-Flash
Red
Scan code flashes 3 times, alternates
then
or
then
Off
Alignment Mode -
Beam 1 Blocked
Pass
internal
tests
Off Off
Zone 1 Red
5
Others Off
Off
Alignment Mode -
Beam 1 Clear
Align
Beam 1
On Red
Zone 1 Green
Others Red or
Green
Total number of blocked beams Off
Run Mode - Clear
Align all
beams
On
On or Flashing
Green
6
All On Green Off Off On
Run Mode -
Blocked
Beam(s)
blocked
On Red Red or Green
5
Total number of blocked beams Off
Noise Detected -
Reset Interface
Flashing
Continues
previous reading
Continues
previous
reading
Noise Detected -
EDM Interface
Continues
previous
reading
Continues
previous reading
Flashing
Lockout
Internal/
external
fault
Off Flashing Red All Off
Displays error code (see Troubleshooting on page
77)
Off
Latch Output Configured
Operating Mode Required
Event
Reset
Indicator
Status Indicator Zone Indicators Diagnostic Displays OSSD
Outputs
Power-up
Apply
power
Off
Single-Flash
Red
All Single-Flash
Red
Scan code flashes 3 times, alternates
then
or
then
Off
Alignment Mode -
Beam 1 Blocked
Pass
internal
tests
Off Off
Zone 1 Red
5
Others Off
Off
Alignment Mode -
Beam 1 Clear
Align
Beam 1
On Red
Beam 1 Green
Others Red or
Green
Total number of blocked beams Off
5
If beam 1 is blocked, Zone indicators 2–8 will be Off, because beam 1 provides the synchronization signal for all the beams.
6
Flashing if Reduced Resolution is enabled.
7
If beam 1 is blocked, Zone indicators 2–8 will be Off, because beam 1 provides the synchronization signal for all the beams.
EZ-SCREEN
®
14/30 mm Safety Light Screen
www.bannerengineering.com - Tel: + 1 888 373 6767 53