Banner SC22-3 - Confirm Safety Output Configuration; Final Confirmation Step; Exit Configuration Mode

P/N 133487 121
Banner Engineering Corp. • Minneapolis, U.S.A.
www.bannerengineering.com • Tel: 763.544.3164
SC22-3 Safety Controller
Instruction Manual
Appendix C
Confirm Safety Output Configuration
Select Safety Outputs and press OK.
To confirm Safety Output SO1’s configuration, select SO1 and
press OK.
The next series of menus lists the safety-critical configurations
for SO1. Press OK after reviewing each setting.
When SO1 is confirmed, the box in front of SO1 will be checked.
Repeat the confirmation process for SO2 and SO3.
When finished, the Confirm Outputs screen should look like this:
Select < Done > and press OK.
The Confirm Configuration menu now indicates the Inputs and
Safety Outputs are confirmed.
The last step is to confirm the System Settings. Select System
Settings and press OK.
The next series of menus lists the safety-critical system settings.
Press OK after reviewing each setting.
Final Confirmation Step
All of the safety-critical configurations settings have been
confirmed and the configuration can be used in a safeguarding
application. If any changes are made to the configuration, the
confirmation process will need to be repeated.
Exit the Confirm Configuration menu by selecting < Done > and
pressing OK.
Exit Configuration Mode
Select Exit Configuration Mode and press OK to exit
Configuration mode and return to the Run mode display.
The Safety Controller has now been configured. The display
screen should be similar to the one below, if the inputs have
been connected.
NOTE: If the inputs have not been connected, the Controller will
indicate a lockout.