Barco ClickShare CSE-200+ Installation Manual

R5900087 /04 ClickShare CSE-200+96
Image 6-55: Buttons, External access point, mode WPA2-PSK
The SSID of your corporate wireless infrastructure to which the ClickShare Buttons will connect.
2. Fill out Passphrase.
The key used in WPA2-PSK to authenticate onto the wireless infrastructure. This can be a string of 64
hexadecimal digits or a passphrase of 8 to 63 printable ASCII characters.
3. Click Save changes to save the settings.
6.39 Blackboard
About Blackboard
Saving information from a blackboard can be enabled or disabled. When enabled, the information is saved on
hard disk of all connected Buttons, connected ClickShare apps and on the USB sticks connected with the
Base Unit.
How to change the blackboard setting
1. Log in to the Configurator.
2. Click System → Blackboard.
Image 6-56: Save annotations
3. Check or uncheck the check box in front of Allow saving annotations to connected clients and USB sticks.
Checked: annotations on the blackboard can be saved.
Unchecked: no annotations on the blackboard can be saved.
CSE-200+ Configurator

Barco ClickShare CSE-200+ Specifications

General

Wireless Frequency Band	2.4 GHz and 5 GHz
Video Outputs	HDMI
Number of Sources Simultaneously on Screen	2
Native Protocols	AirPlay, Google Cast, Miracast
Wireless Sharing	Yes
Resolution	Up to 4K UHD (3840x2160)
Security	WPA2
Compatibility	Windows, macOS, iOS, Android
Operating System	Windows, macOS, iOS, Android
Frame Rate	30 fps
Output Resolution	Up to 4K UHD (3840x2160)
Audio	HDMI audio
USB	USB-A
ClickShare Buttons	2
Authentication Protocol	WPA2
Wireless Transmission Protocol	IEEE 802.11ac
Reach	30 meters
Maximum Number of Presenters	8
Connection Type	Wireless
Resolution Support	Up to 4K UHD (3840x2160)