R5906852-01 F80 series36
4.2 Power modes
General
The table below details the F80 power modes.
Mode Description
ON (normal) Projector is booted up and the light source is on
READY Projector is booted up but the light source is off
ECO (Standby) Light source is switched off and projector electronics
are powered down
Energy consumption is significantly lowers in ECO (Standby) mode: only <0.5W if network is not
plugged in and 2W with network (Wake-on-LAN).
In ECO (Standby) mode, remote power up (Wake-on-LAN) and local power up (button) are
supported.
4.3 Power mode transitions
4.3.1 General
Transition Diagram
This diagram shows all modes available on the projector (unplug, ON, READY, ECO), and the actions
necessary to change mode.
Image 4-1
-
Projector mains powered
-
Auto transition after x minutes if ECO mode enables
-
Press power On/Off button, remote On/Off button
Getting Started
To Next Page
Loading...
Need help?
General
