R5906852-01 F80 series86
3. Use the ▲ or ▼ key to select Address and press OK button to activate the input box.
4. Use the ▲ or ▼ key to change the selected character.
Use the ◄ or ► key to select another character.
Note: Digits can be entered with the digit keys on the remote control or the local keypad. When a digit
is entered in that way, the next character will be selected automatically.
5. Repeat steps 4 and 5 for the Subnet mask and Default Gateway.
6. Select APPLY and click OK to confirm all changes.
When the connection is established, it is indicated with the connection symbol and the indication Connected.
9.2 Themes
About Themes
Themes are used to apply a predefined functionality to the OSD display. There are two options: light (default)
or dark.
How to select a different interface theme
1. In the main menu, select System Settings →Themes.
Image 9-5: System Settings Menu — Themes.
2. In the themes menu, select the desired Theme.
You can choose one of the following: Light, or Dark.
9.3 Standby ECO
About Standby ECO
When the ECO mode is enabled, the projector will automatically go to ECO standby mode after a time-out
(default 15 minutes). All electronics (including fans, pumps, ...) go down except for a very small wake-up
controller. See section dedicated to the Power Mode transitions for further details.
How to enable the ECO mode
1. In the main menu, select System Settings →Standby ECO.
Image 9-6: System Settings Menu — Standby ECO
GUI – System Settings
To Next Page
Loading...
Need help?
General
