Barco G62 Series - Connecting the Projector with the Power Net

27R5914654 /04 G62 series
2.4 Connecting the projector with the power net
CAUTION: Use only the power cord provided with the projector.
How to connect with local power net
1. Ensure that the power switch stands in the '0' (OFF) position (reference 1)
2. Connect the female side of the power cord with the power input socket of the projector (reference 2)
1
2
Image 2–16
3. Connect the male side of the power cord to the local power net.
Caution: Ensure that the power net meets the power requirements of the projector.
WARNING: Do not attempt operation if the AC supply and cord are not within the specified voltage
and power range.
Installation