6. Setup process of a X8 rental display
6. SETUP PROCESS OF A X 8 R ENTAL DISPLAY
About this chapter
This chapter roughly describes the installation process of the X8 rental display for a base stand (floor mount) or truss (hanging)
configuration. Several process stages refer to one or more of the detailed "Basic setup procedures", page 39.
Floor mount or hanging X8 rental display
The X8 rental tiles can be used in a floor mount or in a hanging rental configuration. These configurations are limited in height,
maximum 3 tiles high for a floor mount and maximum 13 tiles high for a hanging configuration. Furthermore, a floor mount (base
stand) configuration can only be used indoor and must be equipped with a stacker support system at the rear of the display.
WARNING: Safety first. Fence off the installation area b efore starting to i nstall your X 8 rental display. Ensure
you read, understand and follow all safety instructions mentioned in the chapter "Safety", page 3, of this
installation man ual. Fu rthermore, make sure that all installation requirements for your X8 rental display are
fulfilled, see c hapter "Installation requ irements", p age 11.
CAUTION: Cover up the L ED-w all on-site, to protect from dust an d dirt, until the start of the event.
Overview
• Set up a floor mount X8 rental display
• Set up a hanging X8 rental display
R5905160 X8 RENTAL DISPLAY 25/02/2013
31
To Next Page
Loading...
