48
BARRETT PRC-4090 TACTICAL HF SDR TRANSCEIVER - SELCALL
Pagecall
1. Select the channel on which to send the Page-
call (Beacon Call can be used to determine the
best channel)
2. Listen for trafc on that channel. If trafc is
not heard, continue.
3. Press and, if nessecary, press the
icon to show the Call Selection screen.
4. Either:
• Select Pagecall, enter the selcall ID of the
transceiver you wish to contact, type in
the message and press Enter, or
Pagecall (SMS) allows messages of up to 32 characters in INT format, or 64
characters in OEM format to be sent to or received from other transceivers with
Pagecall facilities.
Sending a Pagecall
Receive a Pagecall
When a Pagecall is received, an audible alarm sounds,
any mute is disabled and the Pagecall screen displays
The Pagecall screen shows the Selcall ID and mes-
sage.
Tap
to stop the audible alarm but maintain the
Pagecall screen.
Tap
To close the Pagecall screen.
• Choose a contact from the Contacts icon and then select Page-
call. Type in the message and press Enter.
5. Wait for the call to be sent and listen for the revertive signal that indicates
the call was successful.
• If a revertive tone is not heard try another channel and repeat the
process.
To Next Page
Loading...
