Basil 5700LSR - Operating Instructions; Before Operating Washer; Section; Number

4-1
Operating Instructions Operator Manual 920512-768
4.1 Before Operating
Washer
1. Verify building electrical supply disconnect switch (circuit
breaker) is positioned to ON. Verify steam and water supply
valves are open.
2. Ensure EMERGENCY STOP pushbuttons are pulled.
3. Open chamber door and verify wash chamber is empty and all
material has been removed.
4. Ensure sump filters in bottom of sump are clean and properly
installed.
5. Open printer door and verify sufficient amount of printer paper is
available.
6. The first time you start your washer, place Power switch to ON
position. Display shows:
7. Power-up sequence and printer records:
***********************************
* POWER-UP HH:MM:SSA
YY/MM/DD
BASIL 5700
SERIAL NUMBER 36XXXXXXXX
117-XXX-XXX REV. X
***********************************
NOTE: If nothing is displayed when Power switch is set to
POWER, reinitialize washer using LOCK/UNLOCK/INIT switch
(see S
ECTION 3.6.1, LOCK/UNLOCK/INIT KEY SWITCH, or Section
7, Troubleshooting).
8. Mode Selection screen appears.
IMPORTANT: When operating your unit for the first time, an
alarm message showing: "Detergent Name" INJ NOT REACHED;
pH CAN’T BE NEUTRALIZED or DESCALER PUMP IS
IMPORTANT: A listing of the Safety Precautions to be observed when operating this Cage and Rack
Washer can be found in S
ECTION 1. Do not operate equipment until you have become familiar with this
information.
WARNING – SLIPPING HAZARD:
To prevent slips, keep floor
dry. Promptly clean up any
spills or drippage. If spills or
drippage are detergents or
other chemicals, follow
safety precautions and han-
dling procedures set forth on
detergent or chemical label
and/or Material Safety Data
Sheet (MSDS).
WARNING – CHEMICAL
BURN HAZARD: Washer
chemicals are caustic and
can cause adverse effects to
exposed tissues. Do not get
in eyes, on skin or attempt to
swallow. Read and follow
precautions and instructions
on chemical label and in
Material Safety Data Sheet
(MSDS) prior to handling
chemical, refilling chemical
container or servicing chemi-
cal injection pump or lines.
Wear appropriate Personal
Protective Equipment (PPE)
whenever handling chemical
or servicing chemical injec-
tion pump and lines.
WARNING – BURN HAZARD:
Pipes may be extremely hot.
OPERATING INSTRUCTIONS
4