4-11
Operating Instructions Operator Manual 920512-768
4.5 VHP Cycle (Option) If VHP Ready System option is present, cycle 11 will be VHP cycle.
VHP cycle is used for biodecontamination purposes.
The following cycle description is based on pre-programmed VHP
cycle. See Table 5-1, Cycle Description Chart, for default treatment
values of VHP cycle.
1. Unload washer from any items and rack.
2. In Mode Selection screen, press DOORS CONTROL touch pad;
then, press DOOR CLOSE touch pad to close doors.
3. Press X touch pad until Mode Selection screen appears.
4. In Mode Selection screen, press AUTOMATIC touchpad. Con-
trol advances to Cycle Selection screen.
5. In Cycle Selection screen, press RIGHT arrow until VHP icon
appears. Press VHP touchpad. Display advances to VHP
screen.
6. In VHP screen, press START CYCLE touchpad.
• If Drying option is present, display shows:
IMPORTANT: Remove heat sensitive items from wash chamber
before performing a Drying treatment.
a. Press OPEN LOAD DOOR to unload wash chamber if
necessary. Press OK touchpad.
b. After safety delay a Drying treatment starts. Wash chamber
is dried with hot non-recirculated air.
c. At the end of treatment, press OPEN LOAD DOOR and load
wash chamber if necessary.
d. Once the washer is properly loaded, press CLOSE LOAD
DOOR to close door.
e. Press OK touch pad.
• If no Drying option, VHP Cycle can be performed after a
Vapor exhaust treatment.
IMPORTANT: Ensure wash chamber is completely dry
before performing VHP cycle.
WARNING – PERSONAL
INJURY AND/OR EQUIP-
MENT DAMAGE HAZARD:
Ensure wash chamber is
completely dry before pro-
cessing a VHP cycle.
CAUTION – POSSIBLE
EQUIPMENT DAMAGE:
• Remove any items, acces-
sories or racks from wash
chamber before process-
ing a drying treatment prior
to a VHP cycle. Items will
be damaged by high tem-
perature drying.
• Items processed in the
washer must tolerate tem-
peratures and chemicals
specified in this manual.
Always follow item manu-
facturer's recommenda-
tions for cleaning
instructions.
To Next Page
Loading...