AW00061111000 Installing a GigE Camera
Installation and Setup Guide for ace CL, aviator, beat, pilot, racer, runner, and scout Cameras (Windows) 9
4. A ... Properties window will open as shown below.
5. Look at the list of items in the center of the ... Properties window.
a. Make sure that the Pylon GigE Vision Streaming Filter and the Internet Protocol
Version 4 (TCP/IPv4) items are checked as shown below.
b. If the adapter should be used exclusively for cameras, make sure that all of the other items
in the list are unchecked. (You may need to scroll the list up or down to see all of the items.)
c. Click the OK button to close the ... Properties window.
6. If you have only one network adapter in the computer, the configuration for the filter driver is
complete and you can close the Network Connections window and exit this procedure.
If you have more than one network adapter that should be used with the filter driver, return to
step 2, select one of the other adapters, and perform steps 3 through 5 for each adapter.
To Next Page
Loading...
Need help?
General
