Table of Contents
A: PL120101.IN2
B: PL120100.IN2
E: 03.93 / T. Weiß
G: 05.94 / G. Krajnik
Chapter: INH
Page: 3
1 General
1.1 Introduction
1.2 Area of application
1.3 Explanation of symbols
1.4 Copyright
1.5 Statement of delivery
2 Safety
2.1 Safety regulations
2.2 Alarm signs
2.3 General drawing
2.4 Electrical access protection
2.5 Hydraulic access protection
2.6 Mechanical access protection
2.7 Guarding
2.8 Safety device for handling unit
2.9 Safety device supervision
3 Technical Data
3.1 Dimensions of machine
3.2 Rating
3.3 Diagram / Injection pressure
3.4 Diagram / Injection velocity
3.5 Diagram / Injection volume
3.6 Diagram / Injection stroke
3.7 Diagram / Screw speed
3.8 Diagram / Closing pressure
3.9 Diagram / Closing velocity
3.10 Diagram / Closing stroke
3.11 Fitting dimensions of machine
3.12 Dimensions of mould
4 Transport - Siting
4.1 Spatial requirement plan
4.2 Transport of machine
4.3 Siting of machine
4.4 Oil filling
4.5 Table of hydraulic oils and lubricants
4.6 Connection to cooling water distributor
4.7 Oil cooler fitting
4.8 Connection to power line
4.9 Corrosion protection
4.10 Storage
To Next Page
Loading...