Table of Contents
A: PL120101.IN2
B: PL120100.IN2
E: 03.93 / T. Weiß
G: 05.94 / G. Krajnik
Chapter: INH
Page: 4
?
5 Structure and Function
5.1 Overview of build groups
5.2 Closing unit
5.2.1 Technical description
5.2.2 Mould fitting
5.2.3 Instructions for fitting - adjustment of fitting height
5.3 Injection unit
5.3.1 Technical description
5.3.2 Nozzle change
5.3.3 Instructions for setting - nozzle centre
5.3.4 Change and prestressing of synchronous belt
5.3.5 Screw change and screw cylinder change
5.4 Hydraulic unit
5.4.1 Pump element
5.4.2 Oil tank
5.4.3 Oil filter
5.4.4 Electrical oil filter clogging display (optional)
5.4.5 Oil cooler
5.4.6 Supervision and indication device
5.4.7 Variable capacity pump setting
5.4.8 Relief valve amplifier
5.4.9 Velocity selection of relief valve amplifier
5.4.10 Pressure selection of relief valve amplifier
5.4.11 Setting for maximum pressure protection for
variable capacity pump
5.4.12 Hydraulic oil preheating
5.4.13 Hydraulic core pull (optional)
5.4.14 Hydraulic screw-off device (optional)
5.5 Pneumatic unit
5.5.1 Material feeder device UNIFEED (optional)
5.5.2 Pneumatic core pull
5.6. Electric unit
5.6.1 Electric drive
5.6.2 Control box
5.7 Control
5.7.1 Description of electronic system
5.7.2 UNILOG user manual
UNILOG
1020
To Next Page
Loading...