Spare Parts / Drawings
A: PL120100.080
B: PL120100.080
E: 03.93 / T. Weiß
G: 05.94 / G. Krajnik
Chapter: 8
Page: 1
Chapter 8: Spare Parts / Drawings
8.1 Guidelines for ordering spare parts
The list of spare parts comprises lists of parts reflecting the
volume of the various build groups of the machine. Each
group is assigned a unit number. Each spare part is entered
under a separate item number.
In the left lower corner, these sectional drawings are assigned
DOK numbers which are also featured in the corresponding
lists of parts. This permits the unequivocal identification of the
part in question. In addition, an acknowledgement number
(RM Nr.:) is given as well.
The spare parts lists are simply and clearly structured. The
comprise the item number, an identification number, the
quantity, the quantity unit and a designation in two languages.
In addition, an acknowledgement number (RM Nr.:) is featured
above the DOK number.
When ordering, please contact either your authorized
BATTENFELD dealer or BATTENFELD Austria (see
addresses and phone numbers in chapter 9).
To avoid any possible misunderstanding, please always
give the machine number when ordering spare parts. Also
stipulate the corresponding identification number (ID-Nr.),
the designation and the desired quantity.
8.2 Basic machine data
The machine data sheet contains information on the key data
and spare parts for the mould. Since it is drawn up
simultaneously with the final inspection of the mould (the
serial numbers of the parts supplied by outside companies
are also recorded), it gives an accurate representation of the
condition of the mould at delivery.
To Next Page
Loading...