General
A: PL120100.010
B: PL120100.010
E: 03.93 / T. Weiß
G: 06.93 / T. Weiß
Chapter: 1
Page: 1
Chapter 1: General
1.1 Introduction
This user manual has been written specifically for the
personnel in charge of this Battenfeld product moulding
machine and should be read, understood and precisely
followed by them.
The complete technical documentation should always be
kept close by the machine; it should be accessible to the
operating and maintenance personnel at all times.
It is only through closely following this manual, in particular
chapter 2 “Safety”, that hitches in the operation of the
machine can be avoided, and smooth functioning will be
guaranteed. For this reason, it is essential to make this
manual available to the competent personnel. This should be
done before the startup of the machine since we accept no
liability for any defect or breakdown of the machine arising
out of the ignorance of this manual on the part of the
corresponding personnel!
There exists the possibility to have your personnel trained by
us, either at our plant or at yours. Please contact our Training
Department for further details.
In the case that difficulties should occur in spite of the above,
please contact our Service Department or one of our licensed
representatives (addresses in chapter 9 “Service”) who will
be glad to be of assistance.
This user manual applies only to machines commissioned
according to chapter 3 “Technical Data”.
With respect to the information and data given in this user
manual, we reserve the right to any technical modifications
that may become necessary in order to improve this injection
moulding machine.
To Next Page
Loading...