Baumuller b maXX 1000 - Page 139

Parameter
Parameter manual b maXX
®
1000
Document no. 5.07004.03
139
of 208
4
P2060
This parameter determines the start-up display page after power is applied to the drive.
P2061
This parameter determines the content of the multi function display.
P2060
Start Anzeige 0 to 4
EE Start-up display selection 0
ON BM_u_StartUpDisplaySelection 1:1
Value Meaning
0 Display the frequency command value (Fxxx)
1 Display the actual output frequency (Hxxx)
2 Display the output current in A supplied to the motor (Axxx)
3 Display the content of user-defined unit (Uxxx)
4 FWD/REV command
P2061
Inhalt Multi-Funktions-Anzeige 0 to 14
EE Content of multi function display 0
ON BM_u_MultiFunctionDisplay 1:1
Value Meaning
0 Display the content of user-defined unit (Uxxx)
1 Display the counter value which counts the number of pulses on TRG
terminal
2 reserved
3 Display the actual DC bus voltage in V
DC
of the b maXX
®
1000
4 Display the output voltage in V
AC
of terminals 1U2, 1V2, 1W2 to the
motor