Baumuller b maXX 1000 - Page 89

Parameter
Parameter manual b maXX
®
1000
Document no. 5.07004.03
89
of 208
4
P1110
Assignment of the multi function outputs:
P1110
Multi-Funktions-Ausgang Relais (RA1, RB1, RC1) 0 to 21
EE Multi function output relay (RA1, RB1, RC1) 8
STOP BM_u_MultiFunctionOutputRelayRA1 1:1 -
Value Function Description
0 No function
1 b maXX® 1000 operational Active when the b maXX® 1000 is ready or RUN com-
mand is „ON“
2 Master frequency attained Active when the b maXX® 1000 reaches the output fre-
quency setting.
3 Zero speed Active when command frequency is lower than the mini-
mum output frequency.
4 Over-torque detection Active as long as over-torque is detected. (Refer to
ZP1213– to ZP1215–)
5 Baseblock (B.B.) indication Active when the output of the b maXX® 1000 is shut off
during base block. Base block error code 051D
hex
can be
forced by multi-function input (setting 9).
6 Low-voltage indication Active when low voltage (Lv) is detected
7 Operation mode indication Active when operation command is controlled by external
terminal.
8 Fault indication Active when a fault occurs, see error list ZP0240–.
9 Desired frequency attained Active when the desired frequency ZP1118– is attained.
10 Terminal count value attained Active when the counter reaches terminal count value
11 Preliminary count value attaint Active when the counter reaches preliminary count value
12 Over voltage stall supervision Active when the over voltage stall function operating
13 Over current stall supervision Active when the over current stall function operating
14 Heat sink overheat warning When heatsink overheats, it will signal to prevent OH turn
off the b maXX® 1000. When it is higher than 85°C
(185°F), it will be ON.
15 Over voltage supervision Active when the DC link voltage exceeds level
16 PID supervision Active when the PID function operating
17 Forward command Active when the direction command is FWD
18 Reverse command Active when the direction command is REV
19 Zero speed output signal Active when the drive is standby or STOP
20 Communication warning (FbE,
Cexx, AoL2, AUE, SAvE)
Active when there is a communication warning, e.g. warn-
ing codes: 00A0
hex
, 050E
hex
, 050F
hex
, 0513
hex
, 0514
hex
,
0525
hex
21 Brake control (desired fre-
quency attained)
Active when output frequency ≥ ZP1121–. Deactivated
when output frequency ≤ ZP1122– after STOP command
22 Inverter ready Drive is ready.