Baumuller b maXX 5000 Application Handbook

19
of 76
Application handbook Servo pump function V1 for BM5000
Document No.: 5.17002.02
3INSTALLATION
This chapter describes the servo pump-specific controller connections. This is applicable,
in particular, to the set and actual value sources.
For the connection of the b maXX 5000 device and the remaining control connections,
see Instruction handbook b maXX 5000, 5.09022 or b maXX 5500, 5.13008.
3.1 General information
In general there are different possibilities for reading in the set values for pressure and
volume and the actual value of pressure:
m Analog
m Field bus with add-on module SVP
m Field bus with standard module X6
Furthermore a subdivision can be done depending on the signal form of analog signals.
In this chapter the different possibilities are described in detail.
WARNING!
All notes and in particular safety notes of the Instruction handbook b maXX 5000 or
b maXX 5500 must be considered.
NOTICE!
It is important to ensure that the pump in every operating point is operated within its
specifications. The limitation values for minimal-pressure, pressure-acceleration and
the characteristic-lines for pressure and speed can be found in the technical docu-
mentation of the pump-manufacturer.

Baumuller b maXX 5000 Specifications

General

Brand	Baumuller
Model	b maXX 5000
Category	Servo Drives
Language	English