Baumuller b maXX 5000 Application Handbook

5
of 76
Application handbook Servo pump function V1 for BM5000
Document No.: 5.17002.02
1GENERAL INFORMATION
The application manual provides important information regarding handling the device. A
prerequisite for safe working is compliance with all specified safety information and han-
dling instructions.
Furthermore, the local accident prevention regulations and general safety requirements
applicable to the area of application of the device must be observed.
Before starting any work on the device, completely read through this Application hand-
book and the Instruction handbook of the device, in particular the chapter on safety infor-
mation. The handbooks are an integral part of the product and must be kept in the
immediate vicinity of the device in order to be accessible to personnel at all times.
For commissioning of the device the parameter manual must be used. The parameter
manual contains information to the parameters of the device.
NOTE!
The servo pump is only available for:
m Single axis BM53XX
m Mono units BM55XX
The following versions (or newer) are required:
m Firmware version 1.10
m ProDrive version 1.17.1.11
m SoftDrivePLC Project „SdSP_100100_FW10_00_WT00“
NOTE!
The function servo pump has to be ordered in advance because an afterwards up-
grade is not possible.
The drive add-on servo pump-EX3 is mandatory for using servo pump software.

Baumuller b maXX 5000 Specifications

General

Brand	Baumuller
Model	b maXX 5000
Category	Servo Drives
Language	English