Baumuller b maXX BM4 Series Instruction

Use, compliant with intended purpose
Instruction Handbook b maXX (BM4-F-)ENC-XX (Encoder module)
Document No.: 5.01042.12 Baumüller Nürnberg GmbH
12
of 102
2.3
2.3 Use, compliant with intended purpose
The BM4-F-ENC-XX is used compliant with its intended purpose, if it is built-in/operated
within b maXX 4000 controller, only.
The Encoder module is considered as being used compliant with its intended purpose if
all notes and information of this Instruction handbook and the Instruction handbook
b maXX 4000 5.12008 are adhered to.
2.4 Responsibility of the operating company
The device will be used in commercial areas. Thus, the proprietor of the device is subject
to the legal work safety regulations.
Along with the notes on work safety in this Instruction handbook and the Instruction hand-
book b maXX 4000 5.12008, the safety, accident prevention and environmental protec-
tion regulations valid for the area of application of this device must be complied with.
Whereby:
m The operating company must inform himself about the applicable work health and safe-
ty regulations and ascertain, in a hazard assessment, any additional hazards that could
arise from the special working conditions in the use area of the device. These must
then be implemented in the form of operating instructions for operation of the device.
m This Instruction handbooks must be kept accessible to personnel working with the de-
vice at all times in the immediate vicinity of the device.
m The specifications of the Instruction handbooks must be adhered to completely and
without exception.
m The device may only be operated in a technically faultless and operationally safe con-
dition.
WARNING!
Danger arising from usage for an unintended purpose!
Any usage that goes beyond the intended purpose and/or any non-compliant use of
the device can lead to dangerous situations.
Therefore:
m Only use the device compliant with its intended purpose.
m Note all specifications of this Instruction handbook and the Instruction handbook
b maXX 4000 5.12008.
m Ensure that only qualified personnel work with/on this device.
m When configuring, ensure that the device is always operated within its specifica-
tions.
m The device may only be operated in a technically flawless condition.
m Only operate the device in combination with components approved by Baumüller
Nürnberg GmbH.

Baumuller b maXX BM4 Series Specifications

General

Brand	Baumuller
Model	b maXX BM4 Series
Category	DC Drives
Language	English