RPC SERIES OWNER’S MANUAL
RPC SERIES QUICK START (RPC-3, RPC-3A, AND RPC-5)
________________________________________________________________________________
10
Change Password Default password is <cr>; disabled.
Password is case sensitive.
Change Outlet
From the User Management Menu, select
List
the number of the user to modify, followed
by <cr>. Enter the number of the outlet(s) to
which you want to give or remove access. If
there is more than one outlet, enter the
numbers, separated by commas. Example:
2,6,8.
Default is no outlets selected.
CONFIGURATION
IMPORTANT:
For network access, you must configure the IP
address, subnet mask, and gateway from the serial port.
NOTE:
Network parameters, such as IP Address, require a unit
reset.
IP Address
Enter the RPC unit’s IP address in dotted
decimal format (200.4.3.50).
Default is
0.0.0.0
Subnet Mask
Enter the RPC unit’s subnet mask in dotted
decimal format (255.255.255.0).
Default is
0.0.0.0
Gateway
Enter the RPC unit’s Gateway address in
dotted decimal format (200.4.5.50).
Default
is 0.0.0.0
Unit ID
Enter the RPC unit’s Unit ID (64 chars
max).
Default is RPC-3 or RPC-3A or
RPC-5
To Next Page
Loading...
Need help?
General