BBH SMX Series - Encoder Interface Assignments

Installation manual
HB-37420-810-01-25F-EN SMX100 Installation manual.docx Page 193 of 260
Version: 25F
5.11.2 Assignment of encoder interface
X31/X32
1)
1)
only SMX111(/2), SMX121(/2), SMX112(/2), SMX122(/2)
X33/X34
2)
2)
only SMX111-2(/2), SMX121-2(/2), SMX112-2(/2), SMX122-2(/2)
NOTE:
With the terminals X33/X34 of the modules SMX111-2 (/2), SMX121-2 (/2) and SMX112-2 (/2),
SMX122-2 (/2), the connection is inverse to the presented and to X31/X32 with application of a
incremental counting system.
With encoders not connected inversely to X33/X34, the direction of rotation is thus indicated
inversely. The indicated direction of rotation can be corrected in the software. (see.
programming manual S. 90 FF - "Direction UP/down“)
Sensor assignment
Absolute encoder
Sensor assignment
SSI – Absolute
X 31/X 32