HB-37420-810-01-25F-EN SMX100 Installation manual.docx Page 230 of 260
Version: 25F
The risks to be examined can also be found in applicable regulations and standards, or must
be considered separately by the manufacturer based on his specific knowledge of the
machine.
For machines sold within the EU the minimum risks to be examined are specified in the EU
machine directive 2006/42/EU or in the latest version of this directive.
Further information concerning the risk assessment and the safe design of machines can be
found in the standards
EN 14121 Safety of machines - risk assessment
EN 12100 Safety of machines - basic terms, general design guidelines
Measures to be applied in order to reduce identified risks must at least be of the same level as
the danger itself. The regulations and standards specified above contain examples of such
measures and the associated requirements.
12.2 Required technical documents
The manufacturer is obliged to supply various technical documents. The minimum extent is
also contained in the applicable regulations and standards.
The EU machine directive, for example, requires the delivery of the following documents:
Source BGIA Report 2/2008
The documents must be easy to understand and should be written in the language of the
corresponding country.
To Next Page
Loading...
Need help?
General
