HB-37420-810-01-25F-EN SMX100 Installation manual.docx Page 219 of 260
Version: 25F
7.4 Parameterization
Parameterization takes place via the program SafePLC SMX100. The transmission of these
data to the module requires a programming adapter, the drivers of which must first be installed
by the user. Parameterization is described in the programming manual SMX100
7.5 Function test
In order to guarantee safety of the module, the user must carry out a functional test of the safety
functions at least once in a year. For this purpose the modules used in the parameterization
(inputs, outputs, monitoring functions and logic modules) must be checked with respect to
function or shut-down.
See programming manual.
7.6 Validation
In order to assure the reliability of the implemented safety functions the user must check and
document the parameters and links after the start-up and parameterization has taken place.
This is supported by a validation assistant in the programming desktop (see chapter "Safety
related examination").
To Next Page
Loading...
Need help?
General
