User Manual 65
Utilities
Once the Z axis offset of the two extruders is performed, the printer indicates how many shims need to be installed
in order to keep both nozzles at the same height. This allows it to print in “mirror” and “duplication” modes more
consistently. More information about how to install shims can be found in the Installing shims chapter in this docu-
ment. To know more about how to print in “mirror” or “duplication” mode, go to the Printing modes section in this
document.
3. Manual fine calibration: this is considered a fine-tuning operation and is only recommended for advanced
users. It allows the modification of X, Y offsets between the two nozzles and the Z offsets of the nozzles with
respect to the printing platform.
To Next Page
Loading...
