User Manual 76
Maintenance
Printing surface
Glass printing surface is a very delicate component of the printer, that can break or degrade if not treated properly.
Proper calibration and therefore good printing quality depends on the flatness and cleanliness of this surface.
This is a component that has to be maintained every time you start a printing process. The estimated lifespan of
this component is 500 printing hours, but it highly depends on the material used, the calibration and the type of
printing.
Activity Frequency Tools
Clean the glass printing surface
with warm water and soap
Before each print Spatula
Cloth
Check correct strength of the
clamps
Before each print -
Perform printing surface calibra-
tion
Weekly or after transportation -
Check the glass printing surface for
scratches
Every 300 printing hours -
To Next Page
Loading...
