AR6201-(X0X)
Page 3-6 DV 14300.03/.04 Issue 5 5/2013
The Sidetone (demodulated audio of the transmitted signal) is available
on the headphone output. The Transmit Mode automatically deactivates the
Speaker.
Note: Transmission Mode is automatically terminated (return to
Receive Mode) after 120 seconds of continuous transmitting
even if PTT is still pressed. In this case “STUCK PTT” is
indicated (refer chapter 3.14). For initiation of a new
transmission, /PTT line needs first to become inactive.
3.5 Frequency Selection Modes
The following Frequency Selection Modes can be available on AR6201-(X0X):
-
Standard Mode (only this mode provides the Scan Function)
-
Direct Tune Mode
-
Channel Mode
The three modes (Standard Mode, Direct Tune Mode and Channel Mode)
provide different user pages on the display for convenient selection of
the operating frequency.
A consecutive short press on “MDE” key provide toggling between the
three pages, which appear in the flowing order:
Standard Mode
and
Direct
Tune Mode
and
Channel Mode
and back to
Standard Mode…etc.
The Scan Function is a sub-mode of the Standard Mode, providing
monitoring of two frequencies (Active Frequency and Preset Frequency) at
the same time.
A 2 seconds press on “↕/SCN” key activates/deactivates the Scan Function.
Out of the three pages from the Frequency Selection Modes any page can
be enabled or disabled in the Installation Setup but at least one page
must remain selected (see chapter 2.8.5, screen MDE PAGES in
Installation Setup).
To Next Page
Loading...
