Becker Traffic Pro 4720 - Storing a Specified Destination in the Destination Memory

94
1DYLJDWLRQRSHUDWLRQ
Further information under “Dynamic navigation with
TMC” on page 101.
•
 !!
Provides options for avoiding motorways, ferries or toll
roads.
Selection can be made by turning the right rotary
control , and settings can be changed by pressing the
right rotary control .
Press the control for more than 2 seconds to accept all set-
tings and quit the menu.
1RWH Routes without motorways can only be calculated
for short distances (up to 200 km).
6WRULQJDVSHFLILHGGHVWLQDWLRQLQWKHGHVWLQDWLRQ
PHPRU\
It is not absolutely necessary to store a destination in the des-
tination memory for route guidance. It saves repeated manual
entry, if the destination is required at a later date.
Select
# !! in the route menu and press the
right rotary control to confirm.
Any name of your choice consisting of up to 20 characters can
be entered for the specified destination and then automatically
stored in the destination memory after pressing the right rota-
ry control for more than 2 seconds. See ”Destination mem-
ory” on page 107.
To store, the small tick can also be selected and the right
rotary control briefly pressed.
If you do not wish to enter a name of your choice, press and
hold the right rotary control for more than 2 seconds to
store the address as previously entered in the destination
memory.
The last destination entered can be filed at any position by
turning the right rotary control . The memory position is
confirmed by briefly pressing the right rotary control .
A total of 50 destinations can be stored.
!$&$$!F$!"!
 $!F$!"!
! $!F$!"!
P
 !"#$%&'

NFGHY