Becker Traffic Pro 4720 - Technical Specifications

146
7HFKQLFDOGDWD
7HFKQLFDOGDWD
:DYHEDQGV : FM 87.5 MHz - 108 MHz
MW 531 kHz - 1620 kHz
LW 153 kHz - 282 kHz
SW 5800 kHz - 6250 kHz
)UHTXHQF\UDQJH : 20 Hz - 20 kHz for CD operation
30 Hz - 15 kHz for FM
50 Hz - 2.5 kHz for MW, LW, SW
2XWSXWSRZHU : 4 x 18 Watt
/LQHFURVVVHFWLRQ : min. 0.75 mm²
/RXGVSHDNHULPSHGDQFH :min. 4 Ω
/LQHRXW : 4 x analogue line out (Va max 3Veff at 10 kΩ)
*$/ : In order to utilise the GAL, a square wave voltage
with an amplitude of +4 V - +12 V relative to earth, must be available from the electronic
speedometer of the vehicle. The adjustment is performed in 7 steps of 2.5 dB.
$HULDO : Impedance 50 Ω
$)WHOHSKRQHLQSXW : Max. input voltage 8 V (if interference occurs, a commercially available 1 : 1 transformer
should be connected into the signal cable).
$8;LQSXW :16 kΩ input impedance, max. input voltage 1.7 Veff
7HOHSKRQHPXWH : Low active level < 2 Volt
6XSSO\YROWDJH :12 V
&'FRQQHFWLRQ : The Becker Silverstone 2630 and Silverstone 2660 CD changers can be connected.
3OD\DEOH&'V : Only CDs which conform to DIN EN 60908 may be used.
The use of 8 cm CDs with adapter is not recommended.