Becker Traffic Pro 4720 - Switching Loudness On;Off; Setting the Subwoofer or Centre Speaker Volume; Linear Setting; Setting the Balance

82
*HQHUDORSHUDWLRQ
)DGHU
Press the button and then the multifunction button .
Use the right rotary control for the desired fader setting.
6HWWLQJWKHEDODQFH
Press the button and then the multifunction button .
Set the desired balance level using the right rotary control .
/LQHDUVHWWLQJ
Briefly press the button.
Press the multifunction button -
!65, -3(; is dis-
played. By pressing the multifunction button again the
tone settings for the currently selected signal source (e.g. FM)
are set to an average value.
6ZLWFKLQJORXGQHVVRQRII
Press the button and then the multifunction button .
Using the multifunction button you can select either
loudness on (
) or loudness off ().
Loudness is switched off in MW, LW and SW wavebands.
6HWWLQJWKHVXEZRRIHURUFHQWUHVSHDNHUYROXPH
Press the multifunction button .
Use the right rotary control to set the desired subwoofer
volume level.
(+
!"/ V
(:!9) (+ (3 3; <) +5
(3
)+ " V
(:!9) (+(3 3; <) +5
,+"#)1?
(:!9) (+ (3 3; <) +5
3;
3;
+5
,2!+"00
(:!9) (+ (3 3; <) +5
+5
<)
24,,#"/V
(:!9) (+ (3 3; <) +5