Power On Setup Using a Keyboard
Qlarity-Based Terminal Hardware 101
To change a function:
When at a function that you want to edit, press
[F2] to move to the available options. Press [F1]
and
[F3] to toggle through the options (e.g., “off” and “on”). When the option you want is dis-
played, press
[F2] to select the option and move back to the function name.
Saving and Exiting:
When you are ready to exit Power On Setup, press either
[F1] or [F3] (with a category heading
highlighted) to move to
DONE on the last page, and press [F2]. “Save and Exit” is highlighted.
Press
[F2] to save your changes and exit Power On Setup. To exit without saving the changes,
press
[F3] to move to Exit w/o Save and press [F2].
Refer to section 8.4 for information on specific functions.
8.3 Using a Keyboard
You will use the following keyboard keys in Power On Setup.
<
P> start Power On Setup
← → move between categories, functions, and options
<
Enter> select a category, function, or option
Do the following to start Power On Setup using a keyboard.
1. Turn off power to the terminal.
2. Press and hold the <
P> key as you power on the terminal.
3. Continue to hold <
P> until the words “Power On Setup” appear on the screen, then release
the key.
4. If a password is required, the prompt, “Enter password,” is displayed. Press the arrow keys
(
↑ ↓ ← →) on the keyboard (not the number key pad) to enter the password, and then
press
<Enter>. After the password is entered, Power On Setup starts.
If you enter the password incorrectly, you must power the terminal off and back on and
start over if you want to access all Power On Setup functions.
If a password is required but not entered or entered incorrectly, Power On Setup starts and
some limited functions are available including Display, Calibration, and Done.
Use the keyboard keys described below to select functions and options in Power On Setup.
To move from category to category:
Press
→ to move forward from one category of functions (e.g., Flash Memory, Display, Cali-
bration, etc.) to another. A heading is highlighted when you move to it. Continue to press
→ to
move to the next page. Press
← to move backwards through the categories.
To Next Page
Loading...
Need help?
General
