QTERM-G75 Terminal Installing to NEMA-4 Specifications
Qlarity-Based Terminal Hardware 27
2.4.2 Installing the Terminal
Take the following steps to install the terminal.
1. Verify that the panel surface around the cutout and mounting holes is clean and free of
rough edges. A gasket built into the terminal will seal against this surface. Dirt or imper-
fections on the panel may prevent a proper seal.
2. Place the terminal into the panel cutout (inserting the studs into the mounting holes) and
verify that the terminal is oriented correctly. The touch screen legend may indicate the ori-
entation. If not, you can determine which side should be at the top by the position of the
serial port on the back panel as follows:
• Landscape
When looking at the front of the unit, the back panel serial port(s) should be near the top
of the terminal.
• Portrait
When looking at the front of the unit, the back panel serial port(s) should be on the right
side of the terminal.
Refer to Figure 14.
Figure 14
QTERM-G75 Front Panel Mount
To Next Page
Loading...
Need help?
General
