BEKA PICO Series User Manual

© BEKA 201 !6 All rights reserved
BAL2185_PICO_with_PICOtroniX1_PICOtronic_0816_EN
...a product of BEKA
8.1.3 Change of parameter
The operating mode for the lubrication duration can be changed at any time by means of the diagnose software BEKA-
DiSys(current versionon BEKAwebsite).
Change the label of the control unit displayif theoperating modefor lubricationduration and/ or the setting range for cycle
durationor lubricationduration are changed.
Thedisplay labelcan be orderedif necessary (seetable).
8.2 Operating mode cycle control, time-dependent
The cycle duration can be set in three time ranges (hours or minutes) and the monitoring time can be set by means of the
diagnosesoftware BEKA-DiSys(current version onBEKAwebsite).
Fig.23:
Setting range for cycle time:
0,5to 8h (16 notchesà 0,5 hours)
1to 16min. (16 notchesà 1 minute)
2to 32min. (16 notchesà 2 minutes)
2to 32h (16 notchesà 2 hours)
Thetime rangesetting is doneby means ofthe switchesat the controlunit display (seefig. 22).
Cycle control
time-dependent
Lubrication time
0,5 to 8 h
1 to 16 min.
2 to 32 min.
2 to 32 h
I
1 to 16 min.
10115124
10116308
10115125
10115126
II
2 to 32 min.
10115127
10116309
10112128
10115129
III
2 to 32 sek.
10115130
10116312
10115131
10115132
Revolutions
I
1 to 16
10115133
10116313
10115134
10115135
II
10 to 160
10115136
10116315
10115138
10115139
III
170 to 320
10115140
10116320
10115141
10115142
Lubrication duration
Cycle time

BEKA PICO Series Specifications

General

Brand	BEKA
Model	PICO Series
Category	Water Pump
Language	English