© BEKA 201 !6 All rights reserved
BAL2185_PICO_with_PICOtroniX1_PICOtronic_0816_EN
...a product of BEKA
4. Use in accordance with the regulations
Thecentral lubricationpump is approvedfor theonly industrial use.
Only operate the central lubrication pump if it is installed in/to another machine and operated
together with this. Supply only lubricant according to the machine maufacturer´s specification. The
central lubrication pump must only be used according to the technical data (see chapter 1
„technical data“). Never exceed the mentioned values. Never operate the central lubrication pump
withoutlubricant.
Unauthorized changes not permittedof the central lubrication pump are . We are not liable for damages of machine or
personsthat resultfrom unauthorized use.
Useaccording tothe regulations isalso:
· Observe all chaptersand notesin the operatingmanual
· Carry out allmaintenance works
· Observe work safety and accident preventionall regulations concerning during the life cycles of the central
lubricationpump.
· Observe to have the necessary training and authorization to operate the central lubrication pump and carry out the
necessaryworks.
Another use or a use beyond is not according to the regulations.
5. Scope of guarantee
Guarantee in regards to operational safety, reliability and performance will only be granted by the manufacturer if the
centrallubrication pumpis used accordingto theregulations.
· Assembly,connection andmaintenance arecarriedout byprofessional staff.
· The central lubricationpump isonly used accordingto the operatingmanual.
· Never exceed thelimit valueindicated in thetechnical data.
· Alterations and repairsat thecentral lubrication pumpmay only bedone byBEKA.
Guarantee and warranty will expire in case of damages at the central lubrication pump that results
fromimproper lubricant(e. g. wearof piston, pistonjamming, blockades,brittled sealing etc.).
BEKA does not assume guarantee for lubricants damages also if they were tested and authorized
by the BEKA laboratory as damages due to lubricant (for example overlaying, improper stored
lubricants,batch changesetc.) cannot bereproduced afterwards.
Caution!
Caution!
Caution!
To Next Page
Loading...
Need help?
General
