SpinLite® Full Side Washer
1MANUL961 Belanger, Inc. * PO BOX 5470 * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681 56
Maintenance
Daily
▪ Start every washday with a “Test Wash” to ensure proper operation of all equipment.
▪ Inspect the SpinLite® Full Side Washer Assemblies overall; for damaged or missing foam on
cleaning hubs, loose bolts that may cause wobbling, and worn bearings.
▪ Inspect the component for clogged nozzles. Nozzles can be cleaned by removing the nozzle
bodies and tapping or inserting a thin wire into the nozzle opening.
▪ Check overall performance for any abnormalities.
▪ Hose down the component and surrounding area to remove the majority of the dirt and other debris
that builds up during the washday.
▪ Check for water, chemical, and air leaks after the equipment is turned OFF.
▪ Check all hydraulic hose connections for leaks.
Monthly
▪ Inspect ShineMitt™ cleaning material on hubs for wear or damage, replace as needed.
▪ Grease Arm Pivot Bearings (2 per unit) and Drive Shaft Bearings (2 per unit) using marine grease.
Note: Before GREASING and after GREASING wipe off all bearing seal surfaces and Zerks. Grease
should only be applied until water is pushed out and bearings seals start to swell.
▪ Apply Fluid Film Rust and Corrosion Preventative spray liberally to Arm Pivot Bearings (2 per unit).
▪ Powder Coated Frame: Wash the component frame, refer to Powder Coating Maintenance.
Quarterly
▪ Aluminum Frame: Scrub down aluminum portions of the component with fine steel wool such as
S.O.S. pads and wash with a good degrimer such as Tide laundry detergent and hot water.
Whenever using steel wool on aluminum, always follow the grain to prevent scratching the finish.
To Next Page
Loading...
