Belanger SpinLite - Troubleshooting

SpinLite® Full Side Washer
1MANUL961 Belanger, Inc. * PO BOX 5470 * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681 57
Maintenance
Troubleshooting
Problem
Cause
Solution
Cleaning Hubs not
spinning
• Mechanical failure may be
possible
• Electrical failure
• Check to see if bearings are seized up. If
so, see replacement parts.
• Check motor starter
Cleaning Hubs will not
extend and/or retract
• Faulty electrical signal
• Connection of Extend and
Retract Airlines to Air Panel
and Arm Cylinders
• Check electrical signal
• Verify that the extend and retract airlines
are properly and securely connected at
the air panel and arm cylinders
Inadequate Chemical
/Water spray
• Clogged nozzles
• Clean nozzles by removing nozzle bodies
and tapping or inserting a thin wire into the
nozzle opening
Excessive vibration
• Floor lags may be loose
• Bearing may need replacing
• Make sure that the SpinLite® Full Side
Washer is tightly lagged to the floor
• Check for play in the pivot arm bearings,
if sloppiness is evident, bearings will
have to be replaced. See replacement
parts
LEDs not working
• Wire connections not seated
properly
• Pins in wire connectors may
be bent
• Water inside electrical
connections
• Wear on wires from hub
skins
• Make sure all the electrical connections
between the cable, slip ring, wire harness,
and LEDs are aligned and seated
properly
• Check to make sure that the pins in the
connectors are not bent
• Apply dielectric grease to the electrical
receptor and reconnect the connectors
• Wrap the connections with electrical tape
to protect them from the car wash
elements
• Verify all wires are secured to the
driveshaft and there is adequate
clearance between the wires and hub
skins to prevent wear on the wires