Safety instructions
14
IRDH575_D00089_05_M_XXEN/01.2020
2.3 Device-specific safety information
Children and unauthorised persons must not have access to
or contact with the ISOMETER®.
Make sure that the operating voltage is correct!
Prior to insulation and voltage tests, the ISOMETER® must be
disconnected from the IT system for the duration of the test.
In order to check the correct connection of the device, a
functional test has to be carried out before starting the
system.
Make sure that the basic settings meet the requirements of
the IT system.
In the event of an alarm message of the ISOMETER®, the
insulation fault should be eliminated as quickly as possible.
If the ISOMETER® is installed inside a control cabinet, the
insulation fault message must be audible and/or visible to
attract attention.
To Next Page
Loading...
Need help?
General
